Clutch, Driving And Driving Pulley; Poor Handling - TGB BLADE 600 Service Manual

1. GENERAL INFORMATION
E. Clutch, driving and driving pulley
FAULT CONDITIONS
Engine can be started but motorcycle
cannot be moved.
Engine running and misfire as
motorcycle initial forward moving or
jumping suddenly (rear wheel rotating
as engine in running)
Poor initial driving (Poor climbing
performance)
F. Poor handling
FAULT CONDITIONS
Steering is heavy
One wheel is wobbling
Vehicle pulls to one side
G. Loss power
1-18
PROBABLE CAUSES
● Drive belt worn out or deformation
● Ramp plate of movable drive face damaged
● Driving pulley spring broken
● Clutch weights broken
● Drive slide-shaft gear groove broken
● Transmission gear damaged
● Clutch weights spring broken
● Clutch outer stuck with clutch weights
● Connection parts in clutch and shaft worn out or burned
● Drive belt worn out or deformation
● Weight roller worn out
● Movable drive face shaft worn out
● Driven pulley spring deformation
● Driven pulley shaft worn out
● Greased in drive belt and driven face.
PROBABLE CAUSES
● Damaged steering bearing
● Damaged steering shaft bushing
● Bent rim
● Improperly installed wheel hub
●Excessive wheel bearing play
● Bent swing arm
● Bent frame
● Swing arm pivot bushing excessively
● Worn
● Bent tie-rod
● Incorrect tie-rod adjustment
● Rear tie air pressure incorrect
● Improper wheel alignment
● Bent frame