Service Precautions - TGB BLADE 600 Service Manual

Service Precaution
● Al w ays use with TGB genuine parts and
recommended oils. Using non-designed parts for
TGB ATV may damage the ATV.
● Speci a l tools are designed for remove and install
of components without damaging the parts being
worked on. Using wrong tools may result in parts
damaged.
● When servicing this ATV, use only metric
tools. Metric bolts, nuts, and screws are not
interchangeable with the English system,
using wrong tools and fasteners may
damage this vehicle.
● Clean the outside of the parts or the cover
before removing it from the ATV. Otherwise,
dirt and deposit accumulated on the part's
surface may fall into the engine, chassis, or
brake system to cause damage.
● Wash and clean parts with high ignition point
solvent, and blow-dry with compressed air.
Pay special attention to O-rings or oil seals
because most cleaning agents have an
adverse effect on them.
1. GENERAL INFORMATION
● Never bend or twist a control cable to prevent
unsmooth control and premature worn out.
● Rubber parts may become deteriorated when
old, and prone to be damaged by solvent and
oil. Check these parts before installation to
make sure that they are in good condition,
replace if necessary.
● When loosening a component, which has
different sized fasteners, operate with a
diagonal pattern and work from inside out.
Loosen the small fasteners first. If the bigger
ones are loosen first, small fasteners may
receive too much stress.
● Store complex components such as
transmission parts in the proper assemble
order and tie them together with a wire for
ease of installation later.
● Note the reassemble position of the important
components before disassembling them to
ensure they will be reassembled in correct
dimensions (depth, distance or position).
● Components not to be reused should be
replaced when disassembled including
gaskets metal seal rings, O-rings, oil seals,
snap rings, and split pins.
1-3