Installation Of Clutch Outer/Driven Pulley Assembly - TGB BLADE 600 Service Manual

8. V-BELT DRIVING SYSTEM
Installation of Clutch OUTER/Driven Pulley
Oil Seal
Assembly
Install new oil seal and O-ring onto movable
driven face.
Apply with specified grease to lubricate the
inside of movable driven face.
Special Grease
O-ring
Install the movable driven face onto driven face.
Install the guide pin and guide pin roller.
Install the collar.
Install friction plate, spring and into clutch spring
compressor, and press down the assembly by
turning manual lever until mounting nut that can
be installed.
Hold the compressor by bench vise and tighten
the mounting nut to specified torque with clutch
nut wrench.
Remove the clutch spring compressor.
Torque value: 5.0~6.0kgf-m
Install driven pulley and drive belt onto drive
shaft.
8-11