TGB BLADE 600 Service Manual page 144

6. CYLINDER HEAD/VALVE
Install cam chain on to sprocket and align the
timing mark on the sprocket with that of cylinder
head.
Align sprocket bolt hole with camshaft bolt hole.
Tighten the sprocket mounting bolts.
Caution
Make sure timing marks are matched.
Install the lock washer so that it is covering the
locating pin.
Bend up the washer tongue positively to lock
bolts.
B
A
Align the line Ⓐ on the generator rotor with the
index mark Ⓑ on the crankcase.
Loosen auto tensioner adjustment bolt and
remove bolt and spring.
Install tensioner and install spring and
adjustment bolt.
Install thermostat(2 bolts)
Install cylinder cover (4 bolts).
Tighten cylinder head cover retaining bolts to
specified torque in a criss-cross sequence.
TORQUE: 1.0~1.2 kgf.m
6-15