Tension Bar Removal; Tension Bar Installation - TGB BLADE 600 Service Manual

- Seizing or binding condition except at
extreme end of either stroke.
- Oil leakage.
- A gurgling noise, after completing one full
compression and extension stroke.
▪ Replace if any faults are present.
Shock Absorber Installation
For installation, reverse the removal procedure.
▪ Make sure to install the proper type of shock
absorber on vehicle.
TORQUE: 48 Nm +/- 6.
TENSION BAR

Tension Bar Removal

1. Safety lifts and supports the vehicle off the
ground.
2. Loosen and remove the bolts, washer and
bushing from the frame.
3. Remove ball joint nut from the A arm or
tension bar.

Tension Bar Installation

For installation, reverse the removal procedure.
TORQUE: 280-300 kgf-cm.
TORQUE: 450-500 kgf-cm
15-1-1. STEERING SYSTEM AND SUSPENSION
15-1-1