Flywheel Installation - TGB BLADE 600 Service Manual

10. ALTERNATOR/STARTING CLUTCH
Install starting driven gear.
Starting driven gear

Flywheel Installation

Align the key on crankshaft with the flywheel
Groove
groove, and then install the flywheel.
Hold the flywheel by drive face with
universal holder, and tighten flywheel nut.
Caution
Flywheel nut not to be reused should be
replaced when disassembled
Torque value:16~18kgf-m
Special tool: Flywheel Puller (440664)
Install reduction gear shaft and reduction gear.
Reduction gear
10-7