Fuel Pump Removal; Fuel Filter Replacement; Fuel Filter Installation; Fuel Pump Relay Connection - TGB BLADE 600 Service Manual

REMOVAL
NOTE:
• Before disconnecting the fuel hose, release the fuel
pressure.
• Always replace the clamp when the fuel hose is
removed or loosened.
• Remove the fuel tank
• Remove the fuel pump mounting nuts.
• Remove the fuel pump assembly and packing.

FUEL FILTER REPLACEMENT

• Disconnect the fuel hose from the fuel filter.
• Remove the screw, clamp and fuel filter.
• Install the fuel filter in the reverse order of removal.
NOTE: The direction of fuel filter with "IN" mark.
INSTALLATION
• Place new packing onto the fuel tank.
• Install the fuel pump, being careful not to damage
the fuel pump wire.
• Install and tighten the fuel pump mounting nuts in
the sequence shown.
TORQUE: 120 kgf/cm.
FUEL PUMP RELAY
• Disconnect the fuel pump relay 5P connector,
remove the fuel pump relay.
• Connect the ohmmeter to the fuel pump relay
connector terminals 30 and 87.
CONNECTION:
• Connect the 12V battery to the fuel pump relay
connector terminals 85 and 86.
CONNECTION:
• There should be continuity only when the 12V
battery is connected.
• If there is no continuity when the 12V battery is
connected, replace the fuel pump relay.
4-1. FUEL INJECTION SYSTEM
4-1-29