Check Water Pump Seal / Cooling System Divulges Inspection; Removal Of Water Pump - TGB BLADE 600 Service Manual

Water Pump
Check water pump seal / cooling system
divulges inspection
● Disassembles the refrigerant drain bolt,
overflows little buckles the N actually fluid,
confirmed overflows the refrigerant whether
has the greasy dirt.
● Turns on lathe the engine oil gauge rule, the
inspection engine oil whether does have
bleaches situation of the emulsified.
If has the above two kind of interior to divulge the
phenomenon, possibly for the water pump inner
two seal damages, the engine cooling system
damages or the cylinder and the cylinder head
gasket damages, please first dismantles the right
crank case to say A confirms the replacement
water pump seal, if does not have the question to
take apart for overhaul cooling system of system
again the cylinder head, the cylinder.

Removal of water pump

Loosen the drain bolt to drain out the
coolant. Remove the water hose.
Loosen 2 bolts and remove the water pump.
Caution
Check the water pump shaft position with
water pump gear shat.
Install water pump and tighten the screw.
12. COOLING SYSTEM
12-7