Left Crankcase Cover Removal; A.c.g. Set Removal; Left Cover Bearing Inspection - TGB BLADE 600 Service Manual

Left Crankcase Cover Removal

Remove left
footrest.
Drain out the engine oil and coolant, and then
remove coolant hoses.
Remove water pump (2 bolts).
Remove 15 bolts from the left crankcase cover.
Remove the left crankcase cover.
Remove dowel pin and gasket.

A.C.G. Set Removal

Remove 3 mounted screws from pulse
generator and then remove it.
Prized open three fixed-points.
Remove 3 screws from left crankcase cover and
then remove generator coil set.
Left Cover Bearing
Inspection
Rotate the bearing with finger to check if the
bearing rotation is in smooth and silent.
Check if the bearing outer parts are closed and
fixed. Replace it if necessary.
Remove the bearing.
10. ALTERNATOR/STARTING CLUTCH
Water pump bolts
Wire
15 bolts
10-3