Drive Belt Removal And Inspection - TGB BLADE 600 Service Manual

8. V-BELT DRIVING SYSTEM
Drive Belt
Removal
Remove left crankcase cover.
Hold drive face with universal holder, and
remove nut and drive face.
Special Tool ： Clutch And CVT Holder (440666)
Hold clutch outer with universal holder, and
remove nut, and clutch outer.
Caution
● Using special service tools for tightening
or loosening the nut.
● Fixed rear wheel or rear brake will
damage reduction gear system.
Push the drive belt into belt groove as diagram
shown so that the belt can be loosened, and then
remove the driven pulley.
Remove driven pulley.
belt. Remove the drive belt from the groove of
driven pulley.
Inspection
Check the drive belt for crack or wear.
Replace it if necessary.
Measure the width of drive belt as diagram
shown.
Service Limit: 27.0 mm
Replace the belt if exceeds the service limit.
Caution
● Using the genuine parts for replacement.
● The surfaces of drive belt or pulley must
be free of grease.
● Clean up all grease or dirt before
installation.
8-4
Do not remove drive