Fuel Unit; Function Of Over-Ride - TGB BLADE 600 Service Manual

16. ELECTRICAL SYSTEM

Fuel Unit

Remove the seat.
Remove the fuel tank cap.
Remove the fuel tank cover and front fender
(refer chapter 13).
Disconnect the coupler of the fuel unit. Remove
the fuel unit (4 bolts).
Caution
● Great care shall be taken not to damage or
bend the float arm of the gauge.
When the float arm shifts to the F position or the
E position, the resistance measured shall be as
follows:
Position
E (Empty)
F (Fuel)
Connect the wiring to the fuel unit and the
ohmmeter as shown.
Connect the fuel unit coupler to the wire harness.
Turn on the main switch.
Move the float arm to verify the proper position
the fuel gauge needle indicates.
Arm Position
Up (Full)
Down (Empty)
Caution
While conducting the test, turn on the
direction indication lamp to make sure that
the battery is in serviceable condition.

Function of Over-ride

Remove the over-ride button from the handle.
Remove it„s coupler.
Check it. Replace the switch if damaged
16-20
Resistance
97.5~107.5 Ω
4~10 Ω
Bargrahpic Position
7 Bargrahpic (Full)
E (Empty)
Full
Empty