Crank Position Sensor - TGB BLADE 600 Service Manual

4-1. FUEL INJECTION SYSTEM

CRANK POSITION SENSOR

• Turn the ignition switch OFF.
• Disconnect the crank position sensor 2P connector.
• Check for loose or poor contact on the crank
position sensor 2P connector.
• Connect the crank position sensor 2P connector.
• Turn the starter motor more than 10 seconds and
then check that the MIL light.
• Turn the ignition switch OFF.
• Disconnect the crank position sensor 2P connector.
• Check for continuity between the crank position
sensor connector terminal and ground.
Connection: Blue (+) － Ground(-)
Standard: No continuity
• Crank the engine with the starter motor, and
measure the crank position sensor peak voltage at
the crank position sensor 2P connector.
Connection: Blue (+) － Sky Blue(-)
Standard: 0.7V
4-1-20