Fuel Tank/Reservoir Removal - TGB BLADE 600 Service Manual

4-1. FUEL INJECTION SYSTEM
FUEL TANK/RESERVOIR (FUEL PUMP ASSEMBLY)
ROMOVAL
• Loosen the fuel tank mounting bolt/nut.
• Release the fuel pressure.
• Disconnect the fuel tank air vent hose and supply
hose.
• Remove the clamp then disconnect the fuel hose.
• Remove the following:
- Fuel tank supply hose
- Fuel tank air vent hose
- Fuel pump/reserve sensor 2 P connector
NOTE: The clamp for one time use only.
• Clamp the fuel return hose.
• Disconnect the fuel return hose at the pressure
regulator.
• Install the following:
- Fuel hose (with "▲" mark)
- Air vent hose
- Fuel pump/reserve sensor 2P connector
NOTE:
• Always replace new clamp while disassemble or
loosen.
• Connect the fuel hose to the pressure regulator.
• Connect the fuel pump/reserve sensor 2P
connector.
• Connect the fuel output hose to the fuel rail with new
clamp.
• While pushing the fuel hose to the fuel rail, install
and tighten the clamp.
NOTE: Do not apply excessive force to the fuel
pipe.
4-1-30
Gray
Air Vent hose
Black/Purple
To Regulator