Drive Face Inspection; Drive Face Reassembly/Installation - TGB BLADE 600 Service Manual

Inspection
The weight rollers are to press movable drive
face by means of centrifuge force.
Thus, if weight rollers are worn out or damaged,
the centrifuge force will be affected.
Check if rollers are worn or damaged.
Replace it if necessary.
Measure each roller's outer diameter.
Replace it if exceed the service limit.
Service limit: 25.0 mm
Weight: 13.5g
Check if drive face boss is worn or damaged and
replace it if necessary.
Measure the outer diameter of movable drive
face boss, and replace it if it exceed service limit.
Service limit: 26.962 mm
Measure the inner diameter of movable drive
face, and replace it if it exceed service limit.
Service limit:27.060 mm
Reassembly/installation
Install weight rollers.
Caution
●The weight roller two end surfaces are
not certainly same.
●In order to lengthen the roller life and
prevented exceptionally
occurrence, Please end surface of the
closure surface
assembles onto movable drive face.
Install ramp plate.
wears the
counter clockwise
8. V-BELT DRIVING SYSTEM
8-7