Ecu Removal And Installation; Power Input Line - TGB BLADE 600 Service Manual

ECU
REMOVAL / INSTALLATION
• Remove the seat set.
• Disconnect the ECU 48P connectors.

POWER INPUT LINE

• Turn the ignition switch ON.
• Measure the voltage between the ECU and ground.
• There should be battery voltage.
• If there is no voltage, check for an open circuit in
Black/White wire between the ECU and roll over
sensor/relay.
• If the wire is OK, check for the roll over sensor/relay.
4-1. FUEL INJECTION SYSTEM
4-1-25