Drive Belt Installation - TGB BLADE 600 Service Manual

Installation
Caution
●Pull out driven face to avoid it closing.
●Cannot oppress friction plate comp in
order to avoid creates the distortion or
the damage.
●Install drive belt onto driven pulley.
Install the driven pulley that has installed the belt
onto drive shaft.
On the drive belt another end to the movable
drive face.
Install the clutch outer . Hold the clutch outer whit
universal holder, and then tighten nut to specified
torque value.
Torque value: 10~12kgf-m
Special Tool ： Clutch And CVT Holder (440666)
Install the drive face, washer and drive face nut.
Hold drive face with universal holder, and then
tighten nut to specified torque value.
Torque value: 10~12kgf-m
8. V-BELT DRIVING SYSTEM
8-5