Gear Oil - TGB blade 300 Service Manual

To this chapter contents
3. LUBRICATION SYSTEM

Gear Oil

Gear oil join bolt
Gear Oil Change
Remove oil join bolt.
Remove drain bolt and drain gear oil out.
Install the drain bolt after drained. Torque
value: 1.1~1.5kgf-m
Make sure that the drain bolt washer can be
re-used.
Add oil to specified quantity from the join hole.
Gear Oil Quantity: 650c.c. when replacing
Make sure that the join bolt washer can be
re-used, and install the bolt.
Torque value: 3.5~4.5kgf-m
Start engine and run engine for 2-3 minutes. Turn
off engine and make sure that oil level is in correct
level.
Make sure that no oil leaking.
Gear oil drain bolt
3-7
PDF created with pdfFactory Pro trial version www.pdffactory.com