Drive Belt; Drive Chain - TGB blade 300 Service Manual

To this chapter contents
2. MAINTENANCE INFORMATION

Drive Belt

Clamp strips
Loosen the 2 clamp strips of left crankcase cover,
and then remove the left crankcase cover vapor
hose.
Remove 9 bolts of the engine left side cover and
the cover.
9 bolts
Check if the belt is crack or worn out.
Replace the belt if necessary or in accord with the
periodical maintenance schedule to replace it.
Width limit: 22.5 mm or above
Teeth
Width

Drive Chain

Check the drive chain
Park the ATV on a level ground, and shift the
transmission onto neutral.
Measure the drive chain slack midway between
the sprockets.
Chain slack: 15~25mm (5/8~1 inch)
Adjust the chain slack
Loosen the axle holder lock nuts and bolts
Insert pin (∮6) to the hold when turn the wheel
clockwise to tight reverse to slack.
Torque: 3.25kgf-m
2-7
PDF created with pdfFactory Pro trial version www.pdffactory.com