Adding The Interface Mtu Into Dd Packets; Configuring The Maximum Number Of External Lsas In Lsdb - H3C S3610-28P Operation Manual

Operation Manual – IPv4 Routing
H3C S3610&S5510 Series Ethernet Switches
Configure the
authentication mode
(simple authentication)
for the interface
Configure the
authentication mode
(MD5 authentication) for
the interface
Note:
The authentication mode and password for all interfaces attached to the same area
must be identical.

3.7.10 Adding the Interface MTU into DD Packets

Generally, when an interface sends a DD packet, it adds 0 into the Interface MTU field
of the DD packet rather than the interface MTU.
Follow these steps to add the interface MTU into DD packets:
Enter system view
Enter interface view
Enable OSPF to add the
interface MTU into DD
packets

3.7.11 Configuring the Maximum Number of External LSAs in LSDB

Follow these steps to configure the maximum number of external LSAs in the Link State
Database:
Enter system view
Enter OSPF view
To do... Use the command...
ospf
authentication-mode
simple [ plain | cipher ]
password
ospf
authentication-mode
{ md5 | hmac-md5 }
key-id [ plain | cipher ]
password
To do... Use the command...
system-view
interface interface-type
interface-number
ospf mtu-enable
To do... Use the command...
system-view
ospf [ process-id |
router-id router-id |
vpn-instance
instance-name ] *
3-39
Chapter 3 OSPF Configuration
Remarks
Optional
Not configured by default
Remarks
—
—
Optional
Not enabled by default; that
is, the interface fills in a
value of 0.
Remarks
—
—