Configuring An Ospf Cost For An Interface; Configuring The Maximum Number Of Ospf Routes - H3C S3610-28P Operation Manual

Operation Manual – IPv4 Routing
H3C S3610&S5510 Series Ethernet Switches

3.6.5 Configuring an OSPF Cost for an Interface

Follow these steps to configure an OSPF cost for an interface:
Enter system view
Enter interface view
Configure an OSPF cost
for the interface
Follow these steps to configure a bandwidth reference value:
Enter system view
Enter OSPF view
Configure a bandwidth
reference value
Note:
If no OSPF cost is configured for an interface, OSPF computes the cost automatically:
Interface OSPF cost= Bandwidth reference value/Interface bandwidth. If the calculated
cost is greater than 65535, the value of 65535 is used.

3.6.6 Configuring the Maximum Number of OSPF Routes

Follow these steps to configure the maximum number of routes:
Enter system view
Enter OSPF view
To do... Use the command...
system-view
interface interface-type
interface-number
ospf cost value
To do... Use the command...
system-view
ospf [ process-id |
router-id router-id |
vpn-instance
instance-name ]*
bandwidth-reference
value
To do...
system-view
ospf [ process-id | router-id
router-id | vpn-instance
instance-name ] *
Use the command...
3-30
Chapter 3 OSPF Configuration
Remarks
—
—
Optional
By default, an interface
computes its cost
according to the baud rate.
The cost value defaults to 1
for VLAN interfaces.
Remarks
—
—
Optional
The value defaults to 100
Mbps.
Remarks
—
—