H3C S3610-28P Operation Manual page 424

Operation Manual – IPv4 Routing
H3C S3610&S5510 Series Ethernet Switches
II. Network diagram
Switch A
DR
Vlan-int1
196.1.1.2/24
Switch B
Figure 3-24 Network diagram for OSPF DR election configuration
III. Configuration procedure
1) Configure IP addresses for interfaces (omitted)
2) Configure OSPF basic functions
# Configure Switch A.
<SwitchA> system-view
[Switch A] router id 1.1.1.1
[Switch A] ospf
[Switch A-ospf-1] area 0
[Switch A-ospf-1-area-0.0.0.0] network 196.1.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] quit
[SwitchA-ospf-1] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] router id 2.2.2.2
[SwitchB] ospf
[SwitchB-ospf-1] area 0
[SwitchB-ospf-1-area-0.0.0.0] network 196.1.1.0 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] quit
[SwitchB-ospf-1] quit
# Configure Switch C.
<SwitchC> system-view
[SwitchC] router id 3.3.3.3
[SwitchC] ospf
[SwitchC-ospf-1] area 0
[SwitchC-ospf-1-area-0.0.0.0] network 196.1.1.0 0.0.0.255
[SwitchC-ospf-1-area-0.0.0.0] quit
[SwitchC-ospf-1] quit
Switch D
Vlan-int1 Vlan-int1
196.1.1.1/24 196.1.1.4/24
Switch C
Vlan-int1
196.1.1.3/24
BDR
3-56
Chapter 3 OSPF Configuration