If You Are Plotting To An Hpgl Compatible Printer - Agilent Technologies 8753ET User Manual

If You Are Plotting to an HPGL Compatible Printer

1. Configure and define the plot, as explained in
4-10 and "Defining a Plot Function" on page
2. Press
Copy PLOT
received.
NOTE Use test sequencing to automatically plot all four S-parameters.
1. Set all measurement parameters.
2. Perform a full 2-port calibration.
3. Enter the test sequence:
Seq
Meas
Copy
Meas
Copy
Meas
Copy
Meas
Copy
Seq
4. Run the test sequence by pressing:
Seq
Plotting Multiple Measurements Per Page Using a Pen Plotter
PLOTTER FORM FEED
NEW SEQ/MODIFY SEQ
Refl: FWD S11 (A/R)
SEL QUAD SELECT DISK
Trans: FWD S21 (B/R)
SEL QUAD LEFT LOWER PLOT
Refl: REV S22 (B/R)
SEL QUAD RIGHT UPPER PLOT
Trans: REV S12 (B/R)
SEL QUAD RIGHT LOWER PLOT
DONE SEQ MODIFY
DO SEQUENCE SEQUENCE 1 SEQ1
1SEQ1
Printing, Plotting, and Saving Measurement Results
"Configuring a Plot Function" on page
4-15.
to print the data the printer has
SEQUENCE 1 SEQ1
LEFT UPPER PLOT
4-21