Ars/F-Route Table - NEC UNIVERGE SV8100 Programming Manual

UNIVERGE SV8100
Level:
IN
Description
Use
kinds of order. If the higher priority trunk groups are busy, the next order group is
used. If a lower priority route is selected, the caller may be notified with a beep tone.
Input Data
Item
No.
01
02
03
04
05
06
07
SV8100 Programming Manual
Program 44 : ARS/F-Route Setup
Program 44-05 : ARS/F-Route Table
ARS/F-Route Table Number
Priority Number
Trunk Group Number
Select the trunk group number to use for the outgoing
ARS call.
Delete Digits
Enter the number of digits to be deleted from the
dialed number.
Additional Dial Number Table
Enter the table number (defined in Program 44-06)
for additional digits to be dialed.
Beep Tone
Select whether or not a beep is heard if a lower
priority trunk group is used to dial out.
Gain Table Number for Internal Calls
Select the gain table number to use for the internal
call (defined in Program 44-07).
Gain Table Number for Tandem Connections
Select the gain table number to use for the tandem
call (defined in Program 44-07).
ARS Class of Service
Select the ARS Class of Service to use for the table.
An extension ARS COS is determined in Program 26-
04-01.

44-05 : ARS/F-Route Table

to set the ARS/F-Route table. There are four
Item
1~500
1~4
Input Data
0~100, 101~150 (100+
Networking ID), 255
0 = No Setting
255 = Extension Call
0~255
(255 = Delete All)
0~1000
0 = Off
1 = On
0~500
0 = No Setting
0~500
0 = No Setting
0~16
Issue 11.0
Default
0
0
0
0
0
0
0
2 - 529