NEC UNIVERGE SV8100 Programming Manual page 887

UNIVERGE SV8100
Alarm
Type Report
No.
57 2 0 IP Collision
Error
58 2 0 Failure of
Outbound IP
Connection
59 --- Reserved ---
60 2 0 SIP
Registration
Error
Notification.
61 0 0 SIP extension
trouble
information.
62 0 0 DtermIP
trouble
information.
SV8100 Programming Manual
Table 2-20 Description of Alarm (Continued)
Name Content of Alarm
Collision(01) indicates the
address programmed in
10-12-01 has been
duplicated. Collision (02)
indicates the address
programmed in 10-12-09
has been duplicated.
Collision(03) ~
Collision(10) indicates the
addresses programmed in
84-26-01 have been
duplicated. (03) is GW1 ~
(10) is GW8.
01: Programming session
is already active.
02: Not setting of IP
Address or Port.
03: Caller ID does not
match.
10: Cannot get IP Address.
11: Socket Open Error.
12: Socket Port Setting
Error.
13: TCP Session Timeout.
1.The registration of the
SIP trunk to the SIP
server failed.
2.The registration of the
SIP trunk to the SIP
server failed in the
authentication.
3.There is no response
from the SIP server to
the SIP registration
request.
1. Failed registration of the
SIP extension terminal.
2. The SIP extension
terminal DSP was not
acquired:
• At registration of SIP
extension terminal to
SV8100.
• When you cannot
acquire the DSP
resource when it is
sent.
The error occurred by the
DtermIP relation.
• When the error occurs
while communicating
with VoIPU or DtermIP.
• When it becomes
impossible to do the
communication between
SV8100 and DtermIP
• When failing in the
acquisition of DSP.
Cause Action
An IP address Confirm that the
programmed in addresses assigned in
either 10-12-01, 10- 10-12-01, 10-12-09,
12-09 or 84-26 is and 86-26 are not
duplicated duplicated anywhere
somewhere on the else on the network.
same segment of
the network. The
system will check
every 5 minutes
and is not a
programmable
increment.
1. The system data 1. Confirm the following
setting is wrong. system data setting --
PRG 10-12, 10-28,
2. The router 10-29, 10-30, and 10-
setting is wrong. 36.
2.Confirm the setting of
3. LAN link error . routers.
3.Confirm whether
4. Net side trouble. abnormality occurs
on the net side.
4. Confirm the
authentication
system data setting
5. Confirm wiring and
the system data
setting. Inquire on
uncertain points of
the maker.
1. The registered 1. Confirm wiring and
port is used by system data setting.
other extension.
2. Confirm whether
2. The license is
insufficient. each equipment
3. DSP of VoIPDB such as access
not acquired. points works
normally.
1. The packet loss Confirm whether each
occurred on the equipment such as
network or the wirings and HUB is
wiring cutting normal.
occurred.
2. DSP of VoIP not
acquired.
Issue 11.0
Alarm
Recovery
Status
The error is ERR
recovered REC
when normally
connecting it.
ERR
REC
ERR
REC
2 - 845