Using Softkeys For Programming - NEC UNIVERGE SV8100 Programming Manual

UNIVERGE SV8100
Use this keypad digit . . .
U
S 7
SING
ECTION
Each UNIVERGE SV8100 display telephone provides interactive Softkeys for intuitive
feature access. The options for these keys will automatically change depending on
where you are in the system programming. Simply press the Softkey located below
the option you wish and the display will change accordingly.
SV8100 Programming Manual
Table 1-3 Keys for Entering Names
When you want to. . .
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! " # $

Enter characters:

#
# = Accepts an entry (only required if two letters on the same
key are needed – ex: TOM). Pressing # again = Space. (In
system programming mode, use the right arrow Softkey
instead to accept and/or add a space.)
Conf Clear the character entry one character at a time.
Hold Clear all the entries from the point of the flashing cursor and to
the right.
S F
OFTKEYS OR
_
Program Mode
Base Service OP1
               
% & '
+ , - . / : ;
P
ROGRAMMING
OP2
( ) ô Õ ú ä ö ü

B E
< = > ?
Issue 11.0

S
¢ £
1 - 7