Did Translation Number Conversion - NEC UNIVERGE SV8100 Programming Manual

Issue 11.0
Level:
SA
Description
Use Program 22-11 : DID Translation Table Number Conversion to specify for
each Translation Table entry (2000).





Use the following chart when entering and editing text for names. Press the key once
for the first character, twice for the second character, etc. For example, to enter a C,
press 2 three times.
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit . . .
2 - 352
Program 22 : Incoming Call Setup

22-11 : DID Translation Number Conversion

The digits received by the system (eight maximum)
The extension the system dials after translation (24 digits maximum)
The name that should show on the dialed extension display when it rings (12
characters maximum)
The Transfer Target – 1 and 2
 If the Transfer Targets are busy or receive no answer, those calls are transferred to the
final transfer destination (Program 22-10).
Operation Mode
When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
Key for Entering Names
 
Program 22 : Incoming Call Setup
UNIVERGE SV8100
Á À Â Ã Ç É Ê ì ó