NEC UNIVERGE SV8100 Programming Manual page 230

Issue 11.0
Item
Item
No.
44
Using
Standard SIP
Display for
CPN
45 NAT Plug &
Play
46 Door Phone
Number
(Read Only)
47 Registration
Expire Timer
for NAPT
2 - 188
Input Data
0 = Disable
1 = Enable
0 = Disable
1 = Enable
0 = Not assigned
1 ~ 8 = Door Phone No.
0 = Disable
60 ~ 65535(sec)
Default Description
0 This Program is used to
Enable or Disable the
system to send INVITE
Fromtag Display attribute
which is sent from a
standard SIP terminal as
CPN to ISDN and if there
is no Display attribute
from standard SIP
terminal, the system will
not refer to either PRG
21-12-01 or 21-13-01 and
no CPN will be sent.
0 Select sending RTP port
number to remote router.
(0) uses result from
negotiation result, (1)
from received RTP
packet. Effective only
when 10-46-14 is to NAT
Mode.
0 Indicates automatically
assigned IP Door Phone
Number after system
registers the Door Phone
port. System assignes the
number not to duplicate with
the Door Phone connected
to 2PGDAD. (Read Only)
180 On a per station basis, this
setting defines the SIP
registration expiry timer. This
setting only applies to
DT700 stations connected
via NAPT. If this value is set
to 0, for a NAPT terminal,
the value in PRG 84-23- 01
is applied.
Note: Version 9000 or higher
is required.
Program 15 : Extension, Basic Setup
UNIVERGE SV8100
Related
Program
10-46-14
10-03
(DLCA)
PGD
10-46-14