NEC UNIVERGE SV8100 Programming Manual page 885

UNIVERGE SV8100
Alarm
Type Report
No.
32 1 0 Remote
watch
function
performs auto
dial.
33 1 0 Fail to auto
dial by
security
function.
34 --- Reserved ---
35 0 0 CS Blocking
36 0 0 CS error
notification 1
37 0 0 CS
transmission
error.
38 0 0 CSIU Dch
Error×
39 0 0 CSIU trans-
mission error.
SV8100 Programming Manual
Table 2-20 Description of Alarm (Continued)
Name Content of Alarm
Remote watch function
performs auto dial.
Fail to auto dial by security
function.
The link of the CSIU and
CS came off.
CS detected the problem
occurring in the air
synchronous signal
between CS-CSIU, BBIC
reset was executed, and it
was restored automatically.
Because CS had not
returned the response to
the control signal from a
main device longer than
the fixed time, it was
restored automatically
specifying reset to
concerned CS with a main
device.
It was restored
automatically specifying
reset to concerned CS with
a main device because a
main device had detected
the control signal from a
main device not normally
reaching CS.
This alarm is integrated
into Communication fault
between the CD-CP00-US
and other PKG, and it is
not used in SV8100.
Cause Action
No action needed/
All auto dial trunks No action needed.
are busy.
1. Outgoing noise. Confirm the following
2. Method of setting when it happens
up CS. frequently during
3. Wiring to operation.
connect CSIU 1 Confirm CS is
unit with CS. normally connected.
4. Hard defect of 2. Confirm the wiring
CS. between CSIU-CS is
5. Hard defect of normal.
CSIU. 3. Exchange CS.
4. Exchange CSIU.
1. Outgoing noise. Confirm the following
2. Method of setting when it happens
up CS. frequently during
3. Wiring to operation.
connect CSIU 1. Confirm CS is
unit with CS. normally connected.
4. Hard defect of 2. Confirm the wiring
CS. between CSIU-CS is
5. Hard defect of normal.
CSIU. 3. Exchange CS.
4. Exchange CSIU.
1. Outgoing noise. Confirm the following
2. Method of setting when it happens
frequently during
up CS.
3. Wiring to operation.
connect CSIU 1. Confirm CS is
unit with CS. normally connected.
4. Hard defect of 2. Confirm the wiring
CS. between CSIU-CS is
5. Hard defect of normal.
CSIU. 3. Exchange CS.
4. Exchange CSIU.
1. Outgoing noise. Confirm the following
2. Method of setting when it happens
up CS. frequently during
3. Wiring to operation.
connect CSIU 1. Confirm CS is
unit with CS. normally connected.
4. Hard defect of 2. Confirm the wiring
CS. between CSIU-CS is
5. Hard defect of normal.
CSIU. 3. Exchange CS.
4. Exchange CSIU.
Issue 11.0
Alarm
Recovery
Status
The error is ERR
recovered
REC
when
reconnecting
or exchanging
it.
This error has ERR
been
REC
recovered
when it is
notified.
This error has ERR
been
REC
recovered
when it is
notified.
This error has ERR
been
REC
recovered
when it is
notified.
2 - 843