NEC UNIVERGE SV8100 Programming Manual page 495

UNIVERGE SV8100
Item
No.
04 Route Table Setup of Target Dial
Set how the system uses the route data
(gathered in Item 3) to route incoming ANI/
DNIS calls.
If option 2 is selected, and the call is to be
routed using the DID table (1), up to 8 digits
can be matched. The number of expected
digits set in Program 22-09-01 must match the
ANI digits defined in Program 22-11-01. For
example, if an ANI/DNIS number received
was 20355512343001 and Program
22-09-01=4, the entry in 22-11-01 must be
1234 with the defined target extension.
If the call is to be routed using the
(0), up to 24 digits can be matched. Define the
range of the
34-09-06. The data is compared to the entries
in Program 13-04-01 and then routed
according to Program 13-04-03.
05 ANI/DNIS Display as Target Dial Name
Set whether or not ANI data should appear on
telephone displays as part of Caller ID display.
06 Routing SPD Table Setup
Define which part of the
Program 13-04 the system uses for ANI/DNIS
Caller ID look-ups and ANI/DNIS routing.
This is required if Items 04 and 05 above are 1
(Caller ID on). When you specify a starting
and end address, the system uses the part of
the table for look-ups.
When you specify a starting address and
length, the system uses that part of the table
for routing. If the incoming ANI/DNIS number
data matches the Number entry in the table,
the system routes according to the associated
Name data. That data can be an extension,
Department Group pilot number, the voice
mail master number or a trunk ring group.
07 Routing on ANI/DNIS Error
Determine how the system handles an ANI/
DNIS call if a data error is detected in the
incoming data string.
SV8100 Programming Manual
Name
SPD
table
SPD
table to be used in Program
SPD
Table set up in
Input Data
0 = SPD Table (Program
13-03)
1 = DID Table (Program
22-11)
0 = Display Off
1 = Display On
Start = 0, 100~1900
End = 0, 99~1999
0 = Play Busy Tone to
Caller
1 = Route Caller to Ring
Group Specified in
Program 25-03
(Transfer)
Issue 11.0
Default
Related
Program
COS 2~15
0 13-04-01
13-04-03
22-09-01
22-11
34-09-05
34-09-06
0 13-04
20-09-02
22-11-03
23-09-04
Start = 0 13-04
End = 0
0 25-03
2 - 453