NEC UNIVERGE SV8100 Programming Manual page 54

Issue 11.0
Item
No.
14
15
16
17
18
19
2 - 12
Item
09 Dial Information Element
ISDN Protocol definition (Only when
Dialing Sending Mode (10-03-08) is set
for 1 (Overlap Sending)
10 Master/Slave System
If set to 0, system is synchronized to the
network clock. If set to 1, system is not
synchronized to the network clock. (For
NW Mode)
11 Networking System No. (for NW
Mode)
13 Loss-Of-Signal Detection Limit
If the transmit/receive voltage is less
than the setting in 10-03-13, the system
considers this as Loss-Of-Signal and
the PRTA does not come up.
--- Not Used ---
--- Not Used ---
PRI Service Two B-Channel
Transfer
Turn On or Off the ability to use the
ISDN-PRI 2 B-Channel Transfer
service.
ISDN Ringback Tone
If Telco does not provide ringback tone,
SV8100 can if 10-03-17 is set
to 1 (Enable).
Type of Number
ISDN Protocol definition.
Select the number type for the ISDN
circuit.
Numbering Plan Identification
ISDN Protocol definition.
Select the Numbering Plan used for the
ISDN circuit.
Input Data
0 = Keypad Facility
1 = Called Party Number
0 = Slave System
1 = Master System
0~50
0 = Level 0 (lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7 (highest sensitivity)
0 = Off
1 = On
0 = Disable
1 = Enable
0 = Unknown
1 = International number
2 = National number
3 = Network Specific number
4 = Subscriber number
5 = Abbreviated number
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
Program 10 : System Configuration Setup
UNIVERGE SV8100
Default
0
0
0
2
0
1
2
1