Adapting The Encoder Data - Siemens sinamics G120 Operating Instructions Manual

Low voltage inverters chassis devices with cu250s-2 control units and encoder evaluation

Hide thumbs Also See for sinamics G120:

Table of Contents

Adapting the encoder data

Preconditions

● You have selected an encoder type that does not precisely match your encoder, because

it is not included in the list of default encoder types.

● You have completely configured the drive.

Procedure with STARTER

Proceed as follows to adapt the encoder data:

1. Select the "Motor encoder" screen form.

2. Select the "Encoder data" button.

3. You have access to the following settings in the "Encoder data" screen form:

– You can change all of the encoder data.

– You can select another encoder. In this screen form, STARTER only lists the encoder

If you wish to set another encoder interface, then you must reconfigure the inverter.

You have adapted the encoder data.

Converter with CU250S-2 Control Unit

Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE

types, which are permitted for the configured interface.

Commissioning

5.3 Quick commissioning with a PC.