Siemens sinamics G120 Operating Instructions Manual page 243

Calculating the load torque
Calculating the moment of inertia
If all of the following conditions are met, the inverter calculates the moment of inertia:
①
•
– The sign of M
– M
②
•
• The inverter has calculated the load torque in at least one direction of rotation.
• Acceleration setpoint > 8 1/s
③
The inverter calculates the load torque again after acceleration.
Converter with CU250S-2 Control Unit
Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE
The rated accelerating torque M
is the same as the direction of the actual acceleration
B
> p1560 × rated motor torque (r0333)
B
speed > p1755
At low speeds, the inverter calculates the load torque
M from the actual motor torque.
L
The calculation takes place under the following con-
ditions:
• Speed ≥ p1226
• Acceleration setpoint < 8 1/s
480 rpm per s)
• Acceleration × moment of inertia (r1493) < 0.9 ×
p1560
For larger changes, the inverter initially cal-
culates the accelerating torque M
ence between the motor torque M
torque M
M = M
B
The moment of inertia J of the motor and
load is then obtained from the accelerating
torque M
(α = rate of change of speed):
J = M
B
must satisfy the following two conditions:
B
(≙ speed change 480 rpm per s)
2
Advanced commissioning
6.5 Motor control
(≙ speed change
2
and frictional torque M
L
- M - M
M L R
– and the angular acceleration α
B
/ α
as differ-
B
, load
M
:
R
243