Siemens sinamics G120 Operating Instructions Manual page 358

Low voltage inverters chassis devices with cu250s-2 control units and encoder evaluation

Hide thumbs Also See for sinamics G120:

Table of Contents

Backing up data and series commissioning

7.1 Saving settings on a memory card

Procedure with the BOP-2

Proceed as follows to transfer the settings from a memory card to the inverter

You have transferred the settings from the memory card to the inverter.

If a USB cable is inserted in the inverter, withdraw it.

Go to the menu level "OPTIONS".

In the "OPTIONS" menu, select "FROM CRD".

Set the number of your data backup. You can back up 99 different

settings on the memory card.

Start data transfer with OK.

Wait until the inverter has transferred the settings from the memory

Switch off the inverter power supply.

Wait until all LEDs on the inverter are dark.

Switch on the inverter power supply again.

Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE

Converter with CU250S-2 Control Unit