Configure The Encoder And Complete The Configuration - Siemens sinamics G120 Operating Instructions Manual

Commissioning
5.3 Quick commissioning with a PC.
Control mode U/f control or flux current control
Position Without position control
control
Commission-
Contrary to "Dynamic Drive Con-
•
ing
trol", a speed controller does not
have to be set
When compared to "Configuration
•
for experts"
– Simplified commissioning us-
ing preassigned motor data
– Fewer parameters
5.3.3.4

Configure the encoder and complete the configuration

9.
10.
11.
12.
You have entered all of the data that is necessary for the basic commissioning of your
inverter.
132
Vector control without an encod-
(FCC)
•
•
•
•
Set the following:
• Select whether the inverter evaluates one or two encoders.
• Select the interface via which the inverter evaluates the encoder.
• Select a standard encoder from the list of encoder types.
– Code number < 1000: Encoders with integrated DRIVE-CLiQ
– 100x: Resolvers with different pole pair numbers
– 2xxx: sin/cos encoder
– 3xxx: HTL/TTL encoders and SSI encoders
If you cannot find your encoder in the list, then initially select the
closest possible encoder type. Continue the configuration, and then
adapt the encoder data.
Adapting the encoder data (Page 133)
This step is only visible if you have configured the basic positioner.
Select the encoder that you use for position sensing.
This step is only visible if you have configured the basic positioner.
Initially, you can skip this step. The settings are explained in the context
of commissioning the basic positioner in the "Basic positioner" function
manual.
Exit basic commissioning by means of
Back up your project
er
Positioning cycles using the "Basic positioner" function > ap-
prox. 500ms
Memory card with "Basic positioner" license required
The "Travel to fixed stop"
function is not possible.
Fewer parameters when compared to "Configuration for ex-
perts"
.
Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE
Vector control with an encoder
No restrictions regarding the
•
functions of the basic posi-
tioner
.
Converter with CU250S-2 Control Unit