Technical Data, Pm250; General Data, Pm250 - Siemens sinamics G120 Operating Instructions Manual

Technical data
10.2 Technical data, Power Modules
10.2.4

Technical data, PM250

Typical inverter load cycles
10.2.4.1

General data, PM250

Property
Line voltage
Output voltage
Input frequency
Output frequency
Power factor λ
Inrush current
Pulse frequency (factory
setting)
Electromagnetic compatibil-
ity
Braking methods
Degree of protection
Environmental conditions for transport in the transport packaging
Climatic environmental
conditions
Mechanical environmental
conditions (shocks and
vibrations)
Protection against chemical
substances
Biological environmental
conditions
464
Version
3-phase 380 ... 480 VAC ± 10%
3-phase 0 VAC ... input voltage x 0.87 (max.)
50 Hz ... 60 Hz, ± 3 Hz
0 ... 550 Hz, depending on the control mode
0.9
< LO base load input current
4 kHz
The pulse frequency can be adjusted up to 16 kHz in 2 kHz steps. The higher the pulse
frequency, the lower the available output current.
Power-dependent data, PM250 (Page 466)
The devices comply with EN 61800-3: 2004 suitable for Category C2 and C3 environments.
DC braking, energy recovery (up to 100% of the output power)
IP20 built-in devices (they must be installed in an electrical cabinet)
The device is suitable for temperatures that conform with 2K4 according to EN 60721-3-2 in
the range -40° ... +70° C
The device is suitable for operation in mechanical environmental conditions that conform
with 2M3 according to EN 60721-3-2
The device is protected against damaging chemical substances that conform with 2C2 ac-
cording to EN 60721-3-2
The device is suitable for operation in biological environmental conditions that conform with
2B2 according to EN 60721-3-2
Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE
Converter with CU250S-2 Control Unit