Install And Connect Brake Relay - Pm240, Pm250, Pm260 Power Modules - Siemens sinamics G120 Operating Instructions Manual

Low voltage inverters chassis devices with cu250s-2 control units and encoder evaluation

Hide thumbs Also See for sinamics G120:

Table of Contents

4.5 Connecting the line supply, motor, and inverter components

Install and connect Brake Relay - PM240, PM250, PM260 Power Modules

Installing the Brake Relay

If you use the optional shield plate, install the Brake Relay on the shield plate of the Power

If you do not use the shield plate, install the Brake Relay as close as possible to the Power

Connecting the Brake Relay to the inverter

The connector for the brake relay is located at the front of the Power Module for the FSC

frame size. These Power Modules have a cable entry for the connecting cable to the Brake

The connector for the Brake Relay is located at the bottom of the Power Module for the FSD

... FSF frame sizes.

Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE

Converter with CU250S-2 Control Unit