Technical Data, Pm340; General Data, Pm340 - Siemens sinamics G120 Operating Instructions Manual

Technical data
10.2 Technical data, Power Modules
10.2.3

Technical data, PM340

10.2.3.1

General data, PM340

Feature
Input voltage
Output voltage
Input frequency
Output frequency
Power factor λ
Starting current
Pulse frequency (factory
setting)
Electromagnetic compatibil-
ity
Braking methods
Degree of protection
Operating temperature
Storage temperature
Contamination
Relative humidity
Environmental requirements Protected against damaging chemical substances according to environmental class 3C2
Shock and vibration
Installation altitude
Approvals
462
Version
1-phase 200 ... 240 VAC
3-phase 0 VAC ... input voltage x 0.95 (max.)
47 Hz ... 63 Hz
0 Hz ... 550 Hz, depending on the control mode
1-phase 200 ... 240
VAC
Less than the input current
4 kHz
The pulse frequency can be increased in 2 kHz steps up to 16 kHz. An
increase in the pulse frequency results in a lower output current.
The devices comply with EN 61800-3: 2004 are suitable for Category C2 environments.
DC braking, compound braking, dynamic braking with integrated braking chopper
IP20 chassis units as supplied from the factory.
IP00 after removing the terminal cover.
Without power reduc-
tion:
HO without power
reduction:
-40° C ... +70° C
Protected according to pollution degree 2 according to EN 61800-5-1: 2007
< 95% - condensation not permissible
according to EN 60721-3-3: 1995
Long-term storage in the transport packaging according to Class 1M2 according to
•
EN 60721-3-1: 1997
Transport in the transport packaging according to Class 2M3 according to EN 60721-3-2:
•
1997
Vibration during operation according to Class 3M2 according to EN 60721-3-3: 1995
•
without power reduc- up to 1000 m above sea
tion: level
with power reduction: up to 4000 m above sea
level
UL, cUL, CE
0.45 ... 0.7
0° C ... +40° C
>+40° C ... +55° C
Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE
Restrictions for special ambient
conditions (Page 469)
Restrictions for special ambient
conditions (Page 469)
Converter with CU250S-2 Control Unit
Details, see
Catalog D 31