Saving Setting On Memory Card - Siemens sinamics G120 Operating Instructions Manual
Low voltage inverters chassis devices with cu250s-2 control units and encoder evaluation
Hide thumbs
Also See for sinamics G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
7.1.1
Saving setting on memory card
We recommend that you insert the memory card before switching on the inverter. The
inverter always also backs up its settings on an inserted card.
If you wish to back up the inverter settings on a memory card, you have two options:
Automatically backing up
Preconditions
● The inverter power supply has been switched off.
● No USB cable is inserted in the inverter.
Procedure
Proceed as follows to automatically back up
your settings:
1. Insert an empty memory card into the
inverter.
2. Switch on the operating voltage of the
inverter.
After the power supply has been switched on, the inverter copies its changed settings to the
memory card.
Note
If the memory card is not empty, then the inverter accepts the data from the memory card.
This data then overwrites the data in the inverter.
• Only use empty memory cards when automatically backing up your settings for the first
time.
Converter with CU250S-2 Control Unit
Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE
Backing up data and series commissioning
7.1 Saving settings on a memory card
351
Advertisement
Table of Contents
