Inverter Function Modules - Siemens sinamics G120 Operating Instructions Manual
Low voltage inverters chassis devices with cu250s-2 control units and encoder evaluation
Hide thumbs
Also See for sinamics G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
5.2.3
Inverter function modules
Function modules
Not all of the inverter functions are enabled in the factory setting. For instance, you must
enable the "Encoder" function, so that the inverter can evaluate an encoder signal.
A function module is a set of inverter functions that can be released or inhibited all together.
You configure the following functions in the basic commissioning:
● Fieldbus interface
● DRIVE-CLiQ interface
● Technology control for higher-level control tasks, e.g. temperature control.
● Basic positioner for the position control of an axis.
● Evaluating encoders
● Extended messages and monitoring functions
● Extended setpoint channel, e.g. motorized potentiometer and fixed setpoints
● Free function blocks for open-loop control functions in the inverter
You configure the following function modules when commissioning your drive:
● You monitor the motor speed using the extended safety functions.
● The extended ramp-function generator allows the motor to be accelerated and braked
smoothly without any jerk.
Converter with CU250S-2 Control Unit
Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE
Extended messages (Page 309)
Commissioning
5.2 Preparing for commissioning
119
Advertisement
Table of Contents
