Setting The Filter For Safety-Related Inputs - Siemens sinamics G120 Operating Instructions Manual
Low voltage inverters chassis devices with cu250s-2 control units and encoder evaluation
Hide thumbs
Also See for sinamics G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
Advanced commissioning
6.8 Safe Torque Off (STO) safety function
6.8.3.6
Setting the filter for safety-related inputs
Requirement
You are online with STARTER or Startdrive online.
Procedure with STARTER and Startdrive
To set the input filter and simultaneity monitoring of the safety-related input, proceed as
follows:
1. Navigate to the filter settings.
Image 6-66
Image 6-67
2. Set the debounce time for the F-DI input filter.
3. Set the discrepancy for the simultaneity monitoring.
4. Only applies to STARTER: Close the screen form.
You have set the input filter and the simultaneity monitoring of the safety-related input.
Description of the signal filter
The following are available for the signal processing of the safety-related inputs:
● A tolerance time for the simultaneity monitoring.
● A filter to suppress short signals, e.g. test pulses.
334
Input filter and simuntaneity monitoring in STARTER
Input filter and simuntaneity monitoring in Startdrive
Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE
Converter with CU250S-2 Control Unit
Advertisement
Table of Contents
