Commissioning
5.3 Quick commissioning with a PC.
Image 5-4
6. When the USB interface is appropriately set, then the "Accessible nodes" screen form
shows the inverters that can be accessed.
Image 5-5
Image 5-6
If you have not correctly set the USB interface, then the following "No additional nodes
found" message is displayed. In this case, follow the description below.
7. Proceed as follows:
You have transferred an inverter accessible via the USB interface into your project.
122
"Accessible nodes" in Startdrive
Inverters found in STARTER
Inverters found in Startdrive
With STARTER
Select the inverter ☑.
•
Press the "Accept" button.
•
With Startdrive
Transfer the inverter into the project using the menu:
"Online - Upload device as new station (hardware and
software)".
Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE
Converter with CU250S-2 Control Unit