Adapting The Encoder Data - Siemens SINAMICS G120D Original Instructions Manual

5.5.5

Adapting the encoder data

Preconditions
● You have selected an encoder type that does not precisely match your encoder, because
● You have completely configured the drive.
Procedure
Proceed as follows to adapt the encoder data:
1. Select the "Motor encoder" screen form.
2. Select the "Encoder data" button.
3. You have access to the following settings in the "Encoder data" screen form:
You have adapted the encoder data.
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
it is not included in the list of default encoder types.
– You can change all of the encoder data.
– You can select another encoder. In this screen form, STARTER only lists the encoder
types, which are permitted for the configured interface.
If you wish to set another encoder interface, then you must reconfigure the inverter.
5.5 Basic commissioning with STARTER
Commissioning
75