Acceptance Tests For The Safety Functions; Recommended Acceptance Test - Siemens sinamics G120 Operating Instructions Manual

Low voltage inverters chassis devices with cu250s-2 control units and encoder evaluation

Hide thumbs Also See for sinamics G120:

Table of Contents

A.8 Acceptance tests for the safety functions

Acceptance tests for the safety functions

The following descriptions for the acceptance test are recommendations that illustrate the

principle of acceptance. You may deviate from these recommendations if you check the

following once you have completed commissioning:

● Correct assignment of the interfaces of each converter with the safety function:

– Fail-safe inputs

– PROFIsafe address

● Correct setting of the STO safety function.

Perform the acceptance test with the maximum possible velocity and acceleration in

order to test the expected maximum braking distances and braking times.

Non-critical alarms

The following alarms are issued following each system ramp-up and are not critical for

Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE

Converter with CU250S-2 Control Unit