Software image signature: HP
For information about the command output, see
display install rollback
Use display install rollback to display rollback point information.
Syntax
display install rollback [ point-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
point-id: Specifies a rollback point ID. If you do not specify a rollback point ID, the command displays
all rollback points.
Examples
# Display all rollback points.
<Sysname> display install rollback
Install rollback information 1 on slot 1:
Updating from flash:/route-1.bin
to flash:/route-2.bin.
Install rollback information 2 on slot 1:
Deactivating flash:/route-2.bin
The output shows that the device has two rollback points.
•
At rollback point 1, flash:/route-1.bin was upgraded to flash:/route-2.bin.
•
At rollback point 2, flash:/route-2.bin was deactivated.
Related commands
install rollback
reset install rollback oldest
display install which
Use display install which to display all software image files that include a specific component or
file.
Syntax
Centralized devices in standalone mode:
display install which { component name | file filename }
Distributed devices in standalone mode/centralized devices in IRF mode:
display install which { component name | file filename } [ slot slot-number ]
Distributed devices in IRF mode:
Table
26.
231