Monitor Cpu-Usage Interval - HPE D6020 Maintenance And Service Manual

slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command enables CPU usage monitoring for the master device. (Centralized devices in
IRF mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The
chassis-number argument represents the member ID of the IRF member device. The slot-number
argument represents the slot number of the card. If you do not specify a card, this command enables
CPU usage monitoring for the global active MPU. (Distributed devices in IRF mode.)
cpu cpu-number: Specifies a CPU by its number. (Centralized devices in IRF mode/distributed
devices in IRF or standalone mode.)
Usage guidelines
After CPU usage monitoring is enabled, the system samples and saves CPU usage at the interval
specified by the monitor cpu-usage interval command. You can use the display cpu-usage
history command to view recent CPU usage.
Examples
# Enable CPU usage monitoring.
<Sysname> system-view
[Sysname] monitor cpu-usage enable
Related commands
display cpu-usage configuration
display cpu-usage history

monitor cpu-usage interval

monitor cpu-usage interval
Use monitor cpu-usage interval to set the sampling interval for CPU usage monitoring.
Syntax
Centralized devices in standalone mode:
monitor cpu-usage interval interval
Distributed devices in standalone mode/centralized devices in IRF mode:
monitor cpu-usage interval interval [ slot slot-number [ cpu cpu-number ] ]
Distributed devices in IRF mode:
monitor cpu-usage interval interval [ chassis chassis-number slot slot-number [ cpu
cpu-number ] ]
Default
The system samples CPU usage every 1 minute.
Views
System view
Predefined user roles
network-admin
Parameters
interval: Specifies the sampling interval for CPU usage monitoring. Valid values include 5Sec for 5
seconds, 1Min for 1 minute, and 5Min for 5 minutes.
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command sets
the interval for the active MPU. (Distributed devices in standalone mode.)
329