HPE D6020 Maintenance And Service Manual page 286

•
e-cpos: Specifies the E-CPOS mode. All interfaces on the interface card act as 2.5 Gbps
CPOS interfaces.
•
efm: Specifies the EFM mode. All interfaces on the interface card act as EFM interfaces.
•
ipsec: Specifies the IPsec mode.
•
oc-12: Specifies the OC-12c/STM-4c mode (622 Mbps). All interfaces on the interface card act
as 622 Mbps CPOS interfaces.
•
oc-12-atm: Specifies the oc-12-atm mode. All interfaces on the interface card act as ATM
interfaces.
•
oc-12-pos: Specifies the oc-12-pos mode. All interfaces on the interface card act as POS
interfaces.
•
oc-3: Specifies the OC-3c/STM-1c mode (155 Mbps). All interfaces on the interface card act as
155 Mbps CPOS interfaces.
•
oc-3-atm: Specifies the oc-3-atm mode. All interfaces on the interface card act as ATM
interfaces.
•
oc-3-pos: Specifies the oc-3-pos mode. All interfaces on the interface card act as POS
interfaces.
•
pos: Specifies the POS mode. All interfaces on the interface card act as POS interfaces.
•
ssl: Specifies the SSL mode.
•
t: Specifies the T mode. All interfaces on the interface card act as CPOS T3-T1 interfaces.
•
t1: Specifies the T1 mode. All interfaces on the interface card act as CPOS T1 interfaces.
•
t3: Specifies the T3 mode. All interfaces on the interface card act as CPOS T3 interfaces.
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware
MSR954 (JH296A/JH297A/JH298A/JH299A/JH373A)
MSR958 (JH300A/JH301A)
MSR1002-4/1003-8S
MSR2003
MSR2004-24/2004-48
MSR3012/3024/3044/3064
MSR4060/4080
You must perform one of the following tasks to activate the new operating mode:
•
Hot swap the interface card if the interface card supports hot swapping.
•
Restart the device.
For more information about interface types, see Interface Configuration Guide.
Examples
# (Centralized devices in standalone mode.) Set the operating mode to E3 for the interface card in
slot 2.
<Sysname> system-view
[Sysname] card-mode slot 2 e3
Please reboot or hot-swap the board or card (if supported) to make the configuration take
effect.
Command compatibility
No
No
Yes
Yes
Yes
Yes
Yes
278