Tftp-Server Acl - HPE D6020 Maintenance And Service Manual

memory successfully. If the destination folder already has a file using the same name, the system
overwrites the existing file. If the download or save-to-memory operation fails, the existing file in the
destination folder is not overwritten.
source-file: Specifies the source file name, a case-insensitive string of 1 to 255 characters.
destination-file: Specifies the destination file name, a case-insensitive string of 1 to 255 characters. If
this argument is not specified, the file uses the source file name.
vpn-instance vpn-instance-name: Specifies the VPN instance to which the TFTP server belongs.
The vpn-instance-name argument is a case-sensitive string of 1 to 31 characters. If the TFTP server
belongs to the public network, do not specify this option.
dscp dscp-value: Specifies the DSCP value for IPv6 to use in outgoing TFTP packets to indicate the
packet transmission priority. The value range is 0 to 63. The default is 0.
source { interface interface-type interface-number | ipv6 source-ipv6-address }: Specifies the
source address for outgoing TFTP packets. If you do not specify this option, the device uses the
primary IPv6 address of the route for the route to the TFTP server as the source address.
•
interface interface-type interface-number: Specifies an interface by its type and number. The
device will use the interface's IPv6 address as the source IPv6 address. For successful TFTP
packet transmission, make sure the interface is up and is configured with an IPv6 address.
•
ipv6 source-ipv6-address: Specifies an IPv6 address. For successful TFTP packet
transmission, make sure this address is the IPv6 address of an interface in up state on the
device.
Usage guidelines
The source address specified with the tftp ipv6 command takes precedence over the source
address specified with the tftp client ipv6 source command.
The source address specified with the tftp client ipv6 source command applies to all TFTP
connections. The source address specified with the tftp ipv6 command applies only to the current
TFTP connection.
Examples
# Download the new.bin file from the TFTP server at 2001::1 and save it as new.bin.
<Sysname> tftp ipv6 2001::1 get new.bin new.bin
Press CTRL+C to abort.
% Total
100 13.9M
Writing file...Done.
For more information about the command output, see

tftp-server acl

Use tftp-server acl to use an ACL to control the device's access to TFTP servers in an IPv4 network.
Use undo tftp-server acl to restore the default.
Syntax
tftp-server acl acl-number
undo tftp-server acl
Default
No ACL is used to control the device's access to TFTP servers.
% Received % Xferd
100 13.9M 0
Average Speed
Dload Upload
0 1206k 0 0:00:11
Table
147
Time Time Time
Total Spent Left
0:00:11 --:--:-- 1206k
18.
Current
Speed