HPE D6020 Maintenance And Service Manual page 304

# (Distributed devices in standalone mode.) Display device information.
<Sysname> display device
Slot No. Brd Type
0 MPU-100
1 MPU-100
2 SPU-300
3 NONE
The output shows that the device has two MPUs and one interface card. The standby MPU is in slot
0, the active MPU is in slot 1, and the interface card is in slot 2.
Table 42 Command output
Field Description
Slot No. Slot number of the card.
Brd Type Hardware type of the card.
Card status:
•
•
Brd Status
•
•
•
Subslot Num Maximum number of subcards that the card supports.
Sft Ver Software version of the card.
Patch Ver Patch version of the card.
# (Centralized devices in IRF mode.) Display device information about all IRF member devices in the
IRF fabric.
<Sysname> display device
Slot No. Board Type
1 MPU
2 MPU
The output shows that the IRF fabric has two member devices, and each member has 28 Ethernet
interfaces and two 10-GE physical IRF ports.
Table 43 Command output
Field Description
Slot No. Member ID of the IRF member device.
Board Type Hardware type of the IRF member device
Status of the IRF member device:
•
Status
•
Role of the IRF member device:
•
Primary
•
•
SubSlots Maximum number of subcards that the member device supports.
Brd Status
Standby
Master
Normal
Absent
Standby—The card is the standby MPU.
Master—The card is the active MPU.
Absent—The slot is not installed with a card.
Fault—The card is faulty and cannot start up.
Normal—The card is an interface card and is operating correctly.
Status
Normal
Normal
Normal—The IRF member device is operating correctly.
Illegal—The IRF member device is not identified.
Master—The member device is the active MPU.
Standby—The member device is the standby MPU.
Loading—The member device is loading the system startup software.
296
Subslot Num Sft Ver
0 AAAAAA-0000
0 AAAAAA-0000
0 AAAAAA-0000
0 NONE
Primary
Master
Standby
Patch Ver
None
None
None
None
SubSlots
12
12