Display Transceiver Interface - HPE D6020 Maintenance And Service Manual

Usage guidelines
This command cannot display information about some transceiver modules.
Examples
# Display the current values of the digital diagnosis parameters on the transceiver module in
interface GigabitEthernet 1/0/1.
<Sysname> display transceiver diagnosis interface gigabitethernet 1/0/1
GigabitEthernet1/0/1 transceiver diagnostic information:
Current diagnostic parameters:
Temp(°C)
36
Alarm thresholds:
High
Low
Table 54 Command output
Field
transceiver diagnostic information
Temp.(°C)
Voltage(V)
Bias(mA)
RX power(dBm)
TX power(dBm)

display transceiver interface

Use display transceiver interface to display the key parameters of transceiver modules.
Syntax
display transceiver interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface, this command displays the key parameters of every transceiver module.
Examples
# Display the key parameters of the transceiver module in interface GigabitEthernet 1/0/1.
<Sysname> display transceiver interface gigabitethernet 1/0/1
GigabitEthernet1/0/1 transceiver information:
Transceiver Type
Connector Type
Voltage(V) Bias(mA)
3.31 6.13
Temp(°C) Voltage(V)
50 3.55
30 3.01
RX power(dBm)
-35.64
Bias(mA) RX power(dBM)
1.44 -10.00
1.01 -30.00
Description
Digital diagnosis information for the transceiver module in the interface.
Temperature in °C, accurate to 1°C.
Voltage in V, accurate to 0.01 V.
Bias current in mA, accurate to 0.01 mA.
Receive power in dBm, accurate to 0.01 dBm.
Transmit power in dBm, accurate to 0.01 dBm.
: 1000_BASE_SX_SFP
: LC
319
TX power(dBm)
-5.19
TX power(dBM)
5.00
0.00