HPE D6020 Maintenance And Service Manual page 346

−
If the IRF fabric has only one MPU, the IRF fabric will be rebooted. If the IRF fabric has a
global standby MPU and the MPU is operating correctly, a switchover will occur.
NOTE:
To ensure correct operation of the IRF fabric and MPUs, do not trigger a switchover by rebooting the
global active MPU if the status of a card is not Stable.
Examples
# Reboot the device when no configuration change has occurred since the last time you saved the
running configuration.
<Sysname> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Reboot the device when the device has configuration changes that have not been saved. Choose
to save the running configuration.
<Sysname> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
Current configuration will be lost after the reboot, save current configuration? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
flash:/startup.cfg exists, overwrite? [Y/N]:y
Validating file. Please wait...
Configuration is saved to flash successfully.
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Reboot the device when the device has configuration changes that have not been saved. Choose
not to save the running configuration..
<Sysname> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
Current configuration will be lost after the reboot, save current configuration? [Y/N]:n
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Reboot the device immediately without performing software check.
<Sysname> reboot force
A forced reboot might cause the storage medium to be corrupted. Continue? [Y/N]:y
Now rebooting, please wait...
# (Distributed devices in standalone mode.) Reboot the interface card in slot 2.
<Sysname> reboot slot 2
Start to check configuration with next startup configuration file, please wait..
.......DONE!
This command will reboot the specified slot, Continue? [Y/N]:y
Now rebooting, please wait...
# (Distributed devices in standalone mode.) Reboot the interface card in slot 2 by force.
Use the display system stable state command to display system stability and status
information.
338